Front End Setup

Discussion in 'PSI Superchargers Tech Questions' started by Mac, Jun 2, 2011.

  1. Mac

    Mac Member

    Joined:
    Oct 8, 2005
    Messages:
    452
    Likes Received:
    0
    I have a TAFC chassis that has bolt on a-arms with ONE adjustable rod end on the top mount so I don't have a ton of adjustment but some. What should my camber be? O degrees? I don't imagine I can adjust the caster much with only one rod end on the top mount but I will check it also in should be positive 8-10 degrees? As for toe I was told around 1/8" toe in?
     
    #1
    Mac, Jun 2, 2011
  2. Peacemaker AFC

    Peacemaker AFC New Member

    Joined:
    Mar 30, 2011
    Messages:
    106
    Likes Received:
    0
    Chassis Setup

    You are correct on the toe. 1/8" in I will check about the caster/camber though.
     
    #2
    Peacemaker AFC, Jun 3, 2011
  3. Mike Keener

    Mike Keener New Member

    Joined:
    May 1, 2009
    Messages:
    22
    Likes Received:
    0
    8-10 degrees should be good.
     
    #3
    Mike Keener, Jun 3, 2011
  4. nitrowannabe

    nitrowannabe Member

    Joined:
    Oct 9, 2006
    Messages:
    414
    Likes Received:
    20
    Caster

    Mark Williams prints wants 12deg. caster.
     
    #4
    nitrowannabe, Jun 3, 2011
  5. Mac

    Mac Member

    Joined:
    Oct 8, 2005
    Messages:
    452
    Likes Received:
    0
    The chassis was built in 1996 Holash, built in Canada. I can't see any name on the spindles. I'm going to go 0 degree camber 8-12 caster and 1/8" toe in.
    Sound good??
     
    #5
    Mac, Jun 6, 2011
  6. nitrowannabe

    nitrowannabe Member

    Joined:
    Oct 9, 2006
    Messages:
    414
    Likes Received:
    20
    More caster

    12 degree should be your minimum caster. 15 would be better. 0 camber good.
     
    #6
    nitrowannabe, Jun 7, 2011

Share This Page





XenPorta 2 PRO © Jason Axelrod from 8WAYRUN.COM