FOR SALE: Used F6 Polished Alum. Inductor Injector Assm.

SOLD ~FOR SALE: Used F6 Polished Alum. Inductor Injector Assm.

For the racer that is looking for something different and out of the ordinary with there fuel injector here is just the ticket. It is a polished alum. JDF F6 injector assm. You can go on JDF's website and read about the injector and we will give you the low down on them to the best or our ability. Made from heat treated cast alum. injector weights twenty eight pounds as seen in the pictures and is twenty two inches tall from base mounting surface to top of injector. Bolt pattern is 16.250" on center but the injector does come with a .375" thick blower restraint plate that will adpt. the injector to a conventional 15.250" on center bolt pattern. Injector has a cast in ramp all the way from behind the butterfly down to the injector mounting surface so the air from each butterly will dump out of the hole of the bottom of the injector. Each injector includes a divider that can be taken out or ran to go down in the blower to help with fuel distribution and blower rotor cavitation. Injector is drilled six spots for 1/8" nozzle bodies, has a billet alum. bracket to mount the barrel valve to, drilled in the rear to mount a fuel distribution block to and includes -8 stainless hard line to go from barrel valve to dist. block, billet throttle cable bracket and last but not least a 14.1 blower restraint that the straps are out of certification but RBS can supply new ones at additional cost if the buyer chooses. Butterfly shaft is made from stainless steel and is 7/16" for durability that all standard Enderle hardware will fit on. Butterflies measure 5.00" x 4.625" and are anodized red. Opening in the blower restraint is 13.00" x 4.437". Injector measures 22.00" tall, 5.50" wide, hangs over 7.00" from center of the front bolt hole and from front of injector to rear is 18.00". For more pictures visit www.rbssuperchargers.com #7003-0020 $2,400.00