FOR SALE AT RBS SUPERCHARGERS:Used RCD Std. Cam Bearing Support Gear Drive

Discussion in 'Noonan Classifieds' started by RBS, Nov 11, 2015.

  1. RBS

    RBS Authorized Merchant

    Joined:
    May 6, 2004
    Messages:
    1,095
    Likes Received:
    0
    [​IMG]
    For the racer that runs a standard cam height KB, JP-1, Mopar or Indy Hemi engine block here is a chance to get an RCD internal crank support, crank trigger gear drive cover set up with the cam & idler gear assm. as well as the crank bearing support assm. Gear drive cover is made from billet alum. that that has dual crank trigger provisions machined into the front cover to make mounting a crank trigger ignition a simple chore and also has six 3/8" studs pressed into it that holds a roller needle bearing crank support assm. that gives the crank shaft some extra support and makes for more accurate crank trigger ignition timing. Racer can swap out an existing gear drive with this front cover as most of the industries crank gears will interchange with this idler and cam gear with no issues. Buyer will have to switch over to a center support crank hub, center flange degree ring, center flange bottom blower pulley and RCD fuel pump extension which RBS can help with at additional cost. Everything that comes with the gear drive cover is pictured, anything else needed for installation will have to be purchased separate. For more pictures visit www.rbssuperchargers.com #7011-0010A $750.00.
     
    #1

Share This Page