Engine to rearend alignment bar adapters wanted

I have to back half my car and bought the Mark Williams alignment bar which is 2.5" and I need 3 little adapter rings to slide over it and set in my std hemi mains which are 2.75" I believe.

Does anyone have some of these that they can sell me or is there someone who can make them for me for a reasonable price? My local machinist is slammed doing engines.

Will, I just read the new policy's after posting this. I thought my phone was being screwy with ITA again so if services wanted still cost please let me know and I will happily pay you for this ad.

Thanks,
Trevor Sherwood
727-364-4368

 

Trev...they will be on the Brown Bus tomorrow!

 

Adapter rings

A hunk of .250"wall, 3.00" od, 2.50" id, DOM tubing.
Brake hone the ID so it slips on... cut into two pieces to
fit the front and rear width main.....done....
Cheep too!

Your Pal, Gary

 

Gary

Hi Gary,

I'll call my machinist buddy up in Indiana and see if he can make me a few, he did the last one's for Tim.

Also Tim, I received the loaners....Thanks buddy, we'll get her fixed up and running strong. I had my hearing yesterday so we wait 2-3 months and hopefully I'll finally have some income.

Thanks guys,
Trev