Enderle twin gear billet pump SG810

Discussion in 'PSI Superchargers Tech Questions' started by 32 bantam, Feb 5, 2018.

  1. 32 bantam

    32 bantam Member

    Joined:
    Jan 18, 2007
    Messages:
    176
    Likes Received:
    7
    I acquired a Enderle SG810 fuel pump. It is the twin gear billet pump. I took it apart to check and lube it and I'm not sure it is together right. When I take the end plates off the removable gear plates are ground smooth to the cover side and the "natural" coated surface with the notches at the fuel inlet/outlet are to the inside. My guess is the ground surface would be on the gear side???? But then I'm not sure why there would be any notches??
    I tried everywhere on the internet to find an assembly drawing...but no luck.
    thanks
     
    #1
  2. 32 bantam

    32 bantam Member

    Joined:
    Jan 18, 2007
    Messages:
    176
    Likes Received:
    7
    Got my answer !! Caled RBS and got Enderle's ph. #
    The coated/relieved side goes toward the gears......the ground side is out. It is ground to set the gear clearance.
     
    #2

Share This Page