end rail spacers

Discussion in 'PSI Superchargers Tech Questions' started by dragster156, Feb 4, 2019.

  1. dragster156

    dragster156 Member

    Joined:
    May 31, 2012
    Messages:
    143
    Likes Received:
    4
    Does anyone make end rail spacers to take up most of the room between the intake and the china rail?

    I do have the manifold end retainers brad sells but there is still way to much room. I am sure they are easy enough to make and just pin them in place. But if they make i'll just buy them.

    Thanks
     
    #1
  2. jay70cuda

    jay70cuda Well-Known Member

    Joined:
    Sep 30, 2009
    Messages:
    1,139
    Likes Received:
    35
    I took a piece of flat aluminum piece about 3/4 wide. And screwed it to the rail. Then took the intake and put a o ring groove in it. Best most efficient way to seal it off. It took some time but was way worth it. Just wipe some grease on the o ring and it’s good to go.
     
    #2
  3. kosky racing

    kosky racing Comp Eliminator

    Joined:
    May 11, 2003
    Messages:
    890
    Likes Received:
    48
     
    #3
  4. kosky racing

    kosky racing Comp Eliminator

    Joined:
    May 11, 2003
    Messages:
    890
    Likes Received:
    48
    Hussey also makes a head gasket that is longer on the end rail ears-about a1/4 longer
     
    #4

Share This Page