Dry sump question

I have my first dry sump oil pump and am a liitle confused about which line goes where. It is a System One pump and when installed on the motor it has two AN 16 inputs(?) on the side towards the back of the motor. My pan has only one AN 16 for the pick up. It also has three fittings on the other side. Are two of the supposed to go to two filters and then to my tank? My tank has one inlet at the top and one outlet at the bottom. I saw on System One's website a picture of a loop. Not sure what that is about or is it to not run a filter? Any help would be appreciated. Thanks, Gary

 

Gary, fitting closest to the block facing rearward is from pick-up in pan.
Fitting closest to block and head facing forward goes through filter and then into tank.
Fitting closest to block and pan facing forward has a loop going to fitting facing forward and away from block.
Fitting facing rearward and away from block is inlet from bottom of tank.
Hope this helps. If you have any questions call me. Joe 559-287-0952

 

Thanks, Sandracer..