Different clutch can stud locations

Discussion in 'PSI Superchargers Tech Questions' started by altered8, Jul 6, 2016.

  1. altered8

    altered8 Member

    Joined:
    Mar 9, 2005
    Messages:
    63
    Likes Received:
    1
    I have a 8 5/8 browell steel can and tried fitting a trick titanium can but the large studs in the engine plate are in different locations. Is there a difference between can manufacturers or funny car to pro mod cans?? I can make a new engine plate but the trick can fouls my funny car rails in two locations where the large stud ears are.
     
    #1
    altered8, Jul 6, 2016
  2. Will Hanna

    Will Hanna We put the 'inside' in Top Alcohol
    Staff Member

    Joined:
    May 6, 2003
    Messages:
    6,706
    Likes Received:
    133
    What you are referring to is "quadrant bolts" and yes different chassis builders use different locations. It is not a bellhousing mfg deal.

    Also keep in mind there is a difference between a 6.2 and 6.3 bellhousing. The 6.2 is required in Top Alcohol for a clutch car. It has no starter pocket and has gussets/ribs welded in to give it external bracing. It also has the 3/4" quadrant studs. A 6.3 may or may not have a starter pocket, but usually does not have the extra bracing and usually has 1/2" quadrant studs.
     
    #2
    Will Hanna, Jul 8, 2016

Share This Page





XenPorta 2 PRO © Jason Axelrod from 8WAYRUN.COM