Crower thrust bearing????

Discussion in 'PSI Superchargers Tech Questions' started by JP1GAZ, Aug 23, 2009.

  1. JP1GAZ

    JP1GAZ New Member

    Joined:
    Mar 1, 2009
    Messages:
    130
    Likes Received:
    0
    CAN YOU TELL ME THE MOST POPLAR SIZES OF THRUST BEARING AND FORK FOR A
    CROWER THREE DISC CLUTCH

    CAN IS TRICK TITANIUM 8 1/8th
    OR DO YOU HAVE ONE FOR SALE
    THANKS
    GAZ
     
    #1
    JP1GAZ, Aug 23, 2009
  2. Mike Canter

    Mike Canter Top Dragster
    Staff Member

    Joined:
    Mar 10, 2004
    Messages:
    4,630
    Likes Received:
    189
    With the clutch all zeroed out and set up with the airgap you want then you must have at least .370" between the throwout bearing and the clutch fingers. If you have less then use a shorter (thinner) throwout bearing. If you have way too much gap then you may not be able to fully apply the clutch when you push the pedal in so you use a longer (thicker one). You just need to put it together with one in it and set it up and see where you are.
     
    #2
    Mike Canter, Aug 23, 2009

Share This Page





XenPorta 2 PRO © Jason Axelrod from 8WAYRUN.COM