Clutch switch wiring with 2 step and leahy box

Confused here

Ok I am using the blue wire from my clutch switch to activate my 2 step and solonoid for fuel when I press the clutch in. Connected with a relay.

So with my leahy set-up how would I wire that so when my clutch is released it will activate my timersand fuel mgmt?

What is the red wire for on the clutch switch?

Thanks for any help!!!!

Sean

 

When we bought our management from leahy the clutch switch we were supplied had provision for either a normally open circuit and a normally closed circuit.

depending on how you have the switch mounted, we have ours on the clutch pedal, i was use, the normall open side of the switch to run the nos/2 step and the normally closed to operate your timers.

so foot hard on the clutch - the normally open switch becomes closed 2 step on, and the normally closed becomes open and your timers wont start untill you release the clutch.


hope this helps

Clarky

 

i used a nuetral safty switch mounted to a braket under the pedal when you puish the clutch in it will go to the chip side

 

switch

Gotcha was not sure. So the blue wire will activate the 2 step and the red wire would activate the timers when released.

thanks!

sean

 

Sean,

Check your PMs, please...

Thanks,

Mike