clutch help

hi i am after some advice on new car clutch settings the car is 526 cubes 14/71 10.5 crower clutch cant remember 1st gear ratio 3 speed lenco 4.56 gears 33-17 rear tyres 3/4 chassis weighing 3150 pounds new car new driver trying to licence were do you start any help apreciated

 

clutch

I don't want to sound like a a$$hole, but call crower, they will get you close, but you will want to get more info, gear ratios, type of car, (doorcar?)

Hope it goes well

 

crower is not open forr the holidays yes its a door car

 

I would probably start with 4 turns of base. As far as the counterweight is concerned, this is what I always do. If the driver has little or no experience, then I put a medium length bolt and nut on the fingers. This way you won't rattle his brains out on his first pass. Each car is different. I'm working on my first Pro Mod car with a new driver and had no idea where the clutch should be. So I started out conservative. I had the base figured out in 3 runs. First 3 turns, then 4 and 4 1/2 after that. At 4 1/2 turns it rattled the tires, so back to 4 turns. I'm still working on the counterweight. Good luck.

 

thanks any help always appreciated as we dont get much track time in australia