CALLIES ULTRA STEEL RODS / BLOWN ALKY APPLICATIONS

Discussion in 'PSI Superchargers Tech Questions' started by jpbr549, Jun 3, 2016.

  1. jpbr549

    jpbr549 New Member

    Joined:
    Dec 2, 2013
    Messages:
    10
    Likes Received:
    0
    Anyone have any problems with this combo? Ive had two sets bend up like spagetti in two different applications.
     
    #1
    jpbr549, Jun 3, 2016
  2. craig moss

    craig moss Member

    Joined:
    Sep 29, 2006
    Messages:
    574
    Likes Received:
    6
    If your gonna run steel Oliver heavyweight with the bolt upgrade.
     
    #2
    craig moss, Jun 3, 2016
  3. jpbr549

    jpbr549 New Member

    Joined:
    Dec 2, 2013
    Messages:
    10
    Likes Received:
    0
    CALLIES says these are good for over 2500 hp. LOL ALL I HAVE TO SAY IS DONT TRY THEM IM A BLOWN ALKY ENGINE. I just hope my crank and new brodix aluminum block are savable. Block will need two sleeves for sure. And a lot of welding.
     
    #3
    jpbr549, Jun 4, 2016
  4. craig moss

    craig moss Member

    Joined:
    Sep 29, 2006
    Messages:
    574
    Likes Received:
    6
    I've ran the same set of Olivers for 12 years. Got scared and got a new set. I'm using the old ones for a back up engine. I beat the hell out of them... Bad tuneups,detonation ect. I have several buddies that went with callies rods and every one of them had to buy a new block. I do use the magnum crank with good luck though.
     
    #4
    craig moss, Jun 4, 2016

Share This Page





XenPorta 2 PRO © Jason Axelrod from 8WAYRUN.COM