burnout

Discussion in 'PSI Superchargers Tech Questions' started by pop, Sep 30, 2006.

  1. pop

    pop New Member

    Joined:
    Sep 12, 2003
    Messages:
    34
    Likes Received:
    0
    when youve got the burnout throttlestop on and the blades are only open about 3/8 of an inch how do you keep the motor from loading up with fuel during the burnout?
     
    #1
    pop, Sep 30, 2006
  2. RBS

    RBS Authorized Merchant

    Joined:
    May 6, 2004
    Messages:
    1,095
    Likes Received:
    0
    If The Butterflies On The Injector Are Not Opening Up It Will Not Allow The Motor To Rev Up Which Won't Allow The Pump Speed To Come Up Allowing Only Minimal Fuel At Low Rpm's Making For A Nice Burnout. If You Are Running A Little Rich You Can Have Holes Drilled In The Injector Covered With Tape And Have Your Crewchief Pull Them Off To Raise The Idle If Needed Are Use The Air Bleed/plugs Make For A Nicer Cleaner Set Up And You Can Install Down By The Nozzles On The Injector.
     
    #2
    RBS, Oct 1, 2006
  3. nitrohawk

    nitrohawk New Member

    Joined:
    Dec 28, 2003
    Messages:
    1,016
    Likes Received:
    0
    Throttle Stop

    If you are talking about a fuel motor they do the burnout with the fuel shut off particaly closed to reduce the pressure and fuel flow. You can vary the pressure with the shutoff which will effect the burnout.
     
    #3
    nitrohawk, Oct 1, 2006

Share This Page





XenPorta 2 PRO © Jason Axelrod from 8WAYRUN.COM