broken lenco

Discussion in 'PSI Superchargers Tech Questions' started by ogt, Sep 19, 2006.

  1. ogt

    ogt Member

    Joined:
    Aug 16, 2006
    Messages:
    95
    Likes Received:
    0
    Is it possible to brake a lenco output shaft? I havent been nice to it over the years and it has seen plenty of tire. the shaft broke clean in half as well as the u joint at 200mph, not on the starting.
    any thoughts?
     
    #1
    ogt, Sep 19, 2006
  2. Lonnie Houde

    Lonnie Houde Member

    Joined:
    Nov 14, 2005
    Messages:
    252
    Likes Received:
    0
    You need a triple sprag BnJ trans!! Oh, and a screw blower!!:p
     
    #2
    Lonnie Houde, Sep 19, 2006
  3. M Tigges

    M Tigges TAFC

    Joined:
    Jun 11, 2003
    Messages:
    644
    Likes Received:
    1
    We replace them every 75 runs or so! They break right in the snap ring groove.
     
    #3
    M Tigges, Sep 19, 2006
  4. Mike Canter

    Mike Canter Top Dragster
    Staff Member

    Joined:
    Mar 10, 2004
    Messages:
    4,630
    Likes Received:
    189
    $215 from Lenco. Just replaced ours. Ours is a coarse spline and the new ones are stronger than the old ones with deeper snap ring grooves.
     
    #4
    Mike Canter, Sep 19, 2006

Share This Page





XenPorta 2 PRO © Jason Axelrod from 8WAYRUN.COM