Bell Housing Bolt Holes

Does anyone have a drawing, or dimensions for the bell housing bolt and engine dowel locations on Donovan 417 Hemi or a 392 Hemi?
Need to make a motor plate.
Cheers
Dave
david@linkplasinternational.com

 

A small block chrysler is pretty close. I think the dowels and all but 2 of the bolts line up. If you don't get an answer in a couple days I know someone with the dimensions I'll try to get in touch with him

 

Dave,
I have the drawing of the 417. Give me a call at 888-539-9566
Thanks
Dave

 

Expect 2 calls Dave. I made a motorplate a while back and had to use transfer punches to get the basic pattern and then went from there. I probably could have reduced my waste and time if I knew what the dimensions were.

Speaking of bolt patterns.
I am on the lookout for the front view bolt patterns for the 440/426 family, the 331/392 family as well as any other chevy, fords, oddballs. Point me the way home.

Dave Koehler
http://www.koehlerinjection.com

 

dave, you got mail

 

Dave, I have the chevy stuff, I'll try and send it tomorrow.

 

Hi Dave at ProBell,
Im on the other side of the world, so I sent you an email instead calling..
Appreciate if you can contact me by email about the 417 bell housing drawing.
Cheers, Dave

 

If anyone gets stuck I have the 417/early hemi pattern, and chev as well. These include starter locations.

Paul.

thjts@hotmail.com