BBC Sum,er Bros drive

Discussion in 'PSI Superchargers Tech Questions' started by Iron Mike, Apr 6, 2012.

  1. Iron Mike

    Iron Mike New Member

    Joined:
    Nov 26, 2008
    Messages:
    123
    Likes Received:
    0
    On the Front fount drive should you run an oil line to it or is "splash" from the gear drive enough.

    Have seen both and ours is not drilled for it.
     
    #1
    Iron Mike, Apr 6, 2012
  2. overkill69

    overkill69 Member

    Joined:
    May 17, 2005
    Messages:
    826
    Likes Received:
    0
    summer bro

    we burned up a dist gear dry and ran a -3 oil line with jet drilled the smallest hole possible. Worked good after that.
     
    #2
    overkill69, Apr 6, 2012
  3. WANNABE

    WANNABE New Member

    Joined:
    Jun 9, 2003
    Messages:
    328
    Likes Received:
    2
    Take a small drill bit and drill a hole in the oil main oil gallery plug in the front of the block.
    (I can get you the actual size bit, but it is about the smallest one that you can drill without breaking it with a standard hand held drill. :cool:)
     
    #3
    WANNABE, Apr 6, 2012
  4. WIZBANG

    WIZBANG Member

    Joined:
    Nov 8, 2004
    Messages:
    761
    Likes Received:
    2
    You can buy the plugs pre-drilled !
     
    #4
    WIZBANG, Apr 6, 2012
  5. Iron Mike

    Iron Mike New Member

    Joined:
    Nov 26, 2008
    Messages:
    123
    Likes Received:
    0
    We have a spare oil feed of the system one oil filter (was used for oiling hemi top end). How do you mount the jet?
     
    #5
    Iron Mike, Apr 7, 2012
  6. overkill69

    overkill69 Member

    Joined:
    May 17, 2005
    Messages:
    826
    Likes Received:
    0
    I welded the -3 fitting shut and drilled it. We had a LOT of topend oiling issues back then so I didn't dare pull oil from the lifter galley.
     
    #6
    overkill69, Apr 7, 2012

Share This Page





XenPorta 2 PRO © Jason Axelrod from 8WAYRUN.COM