Separate names with a comma.
steel rods ok guys,572 chevy,blown alcohol,14 71 hh blower,55overdrive,oliver steel rods,50 plus runs,bearings just as they came out of the...
fasttimes,18 lbs is a good starting point for the port check,a high helix blower has a pie shaped opening in the front of the blower,the setback...
oil div6 safety.things to consider when choosing oil weight,bearing clearance,amount of hp produced&do you preheat oil before run.also,rpm,s.we...
on my kb olds i have .008 to .010.clearance,it will grow some as it gets warmed up.
reciever groove i have the same setup on one of my engines,with .012 up,you need .012 to .015 deep groove,.060 wide.it works for me.
clayto,i see no reason you can,t do it with a standard helix blower,afterall,it is less efficient than a hh blower
high speed clayto,when you position the high speed lean on the port line side of the barrelvalve,it is easier to get the correct percent of fuel...
rods r&r vs brooks.i have installed both brands in blown alky engines,and had no rod failures due to the rods.i recall one time the arias 8.3L...
4 years at 40 runs and no failure,you answered your question,don,t change your maintance program,it,s working.a friend of mine uses miller rods in...
arias i forgot to mention,arias then started to make a block they called the 10L it is basically a carbon copy of a kb600 also known as kb...
arias arias origionally made the 8.3L block,that program was baught buy a company called [barnes fontana].then the company split ,barnes went on...
john111,we have a heat element in the tank,and on the other engine [wet sump] a heatstrip on bottom of pan.don,t try heating the oil before you...
we run a kb olds 540 in a promod boat, we run 3.5 to4.0 on mains and 3.5 on rods,[brooks alumimum] very mild tuneup[ 1550hp]we run a drysump with...
10.5 or11.to one is good for blown alcohol,if you go to high,tuning is more difficult.1500 hp easily obtained with 526 cu in.25 lbs boost should...
claude,when you changed heads&intake your 509 is now a different anamil.because the head&intake combination flows different than your old...
I HAVE USED A MSD 20 AS IT CAME FROM MSD IN A DUNN DRIVE FOR 2 SEASONS WITH NO PROBLEMS.
bob kraemer stated that 2 much valvesprimg preassure is just as bad as not enough.with due respect ,i cannot agree with him on that,fact is 90...
almost all msd products will be adversly affected by solid core wire,use msd wires and the tack should work properly.solid core or poorly...
nitrohawk,2 good questions and nobody even guessing.il bet jerry darian and a few others can answer them,id also bet they won,t.
if i were you i would not try the 120 main,as bob meyer said,and i totally agree,that probibally will put you lean enough to take 8 pistons before...
