Separate names with a comma.
We switched out twd truck over to a set back last year and we basically now have all the nozzles in the intake the same and all the temps are very...
How many egt boxes do you have available? And will they work with the iq3 racepak?
Check your blower shaft that will cause it to start and die.
Gas cart We used our old gas cart to pull around our 6200lbs truck from time to time when we had blacktop or concrete pit areas. You be surprised...
14.71 F-11 superman
best for $$ We run a new f11 from fowler. Best bang for your buck and will make plenty of power. We are back down to about 50 over from 60+. We...
psi I have one along with 2 super mags. I will take 200 for the Rev limiter and 275 each for the mags. Let me know if your interested....
Rods I have a set of GRP 7.066. They have 12 passes on them before we changed rod length. I will take 225 plus the ride if your interested. Let...
fuel storage I have seen several guys put a 100 gallon or larger plastic tank in the top of their trailer to store fuel in. They all have a line...
Brass gear Check the brass gear on the mag base shaft. It may be worn or the shaft may be bent. We have had the same thing happen and the brass...
K-11 We have a couple Kobelco K- 11 for sale $6000. If you want any pictures or more info call Donnie at 859-393-0244. All are fresh back from...
We ran our waterman without the manifold and didn't have any trouble. We had to remove it for more room, we ran the pump bolted directly on the...
Double check Sean make sure where you are going to run will let you use a crank trigger. I know it is dumb but some places make you use the mag...
Different We use Terry Neer in Columbus, Ohio. He did work for fowler before he started his own shop. He is very good we have been going to him...
Tried it We polished a mag manifold before and after we got it done it looked great then as time (2 weeks) went by it turned back to the same old...
I already have 3 spread bore blocks but I measure 2" on the lifters center to center. The other engine is still together so I can't check it and...
What are the spread of the lifters on a std spread block and a block with spread lifters? I thought it was around .100 or .200 but would just like...
10l I think Eddie Carey from KY bought the rights to the 10l stuff a few years ago and started to make billet blocks. Not 100% if he is selling...
Coils Hey Dave it wasn't the coil you got from me was it? If you need anymore Mallory stuff let me know I have a couple mags and coils left....
move it I would just remove the front cover then drill and tap a new hole for the relief valve and put a plug in the old hole. If you weld it I...