Separate names with a comma.
Any Brad 3 rocker Stands and shafts available???? Cheers
Hi ITA members, I'm currently running Brad 3 fat heads on a short deck (.500") KB motor, we are going to Brad 6 heads, are inlet ports the same???...
Hi all, I'm running a 451 cube KB short deck Hemi, Brad 3 fat heads, 14/71 with 23% od 30psi, now I'm swapping from a supermag 3 running 28*...
Newby Engineering AUS
Hey guys anyone have ideas on crown wheel bolt tensions, cage through bolt tensions, pinion preload on a mark Williams 9/9.5" centre ???? Cheers
A few years back we ran u 426 style blown alcohol Hemi with a Bruno, we ran an adapter plate made by Newby Engineering AUS, worked a treat later...
Hey guys is .007" too much oil clearance for a Crank in a KB hemi???? All are around .005" except rear Cheers
Hi Guys, After some answers from anyone who has run AJPE war heads in alcohol engines???? Was there any major differences with rod/piston...
Yeah that was the first plans dave, motor is near buggered and I would be too embarrassed to sell it with the damaged cam bearing that has done 3...
Hi guys had anyone had dramas removing the oil restrictors in a KB??? Put 5/32 hex key in and kept twisting??? Where can these be purchased from...
Thanks heaps mate, I received alot of B9ES plugs with the motor, I see everyone runs 10s, this KB wont be rotating the earth till we get it...
Hi guys, just wondering if anyone out there is using brad 3 fat heads, chasing valve clearences, cold and hot, think it was .014''C and 0.22''H,...
Hey marty, Its only running as a bracket car on alcohol not fuel, its a 14/71 hi helix littlefield blower that aint turning hard, its got 33"...
Hi all, Im currently building a FED (EX Chuck Tanko) running a 451 KB alcohol hemi on a soft tune, 2 speed lenco, 3.9 Diff gears and a crower...
Hi all I purchased a Birdcatcher hat from good vibs to replace the current square door buzzard more for looks and said it suited 425 cuin and...
