Separate names with a comma.
I have a BAE hemi in a rear engine dirt/mud dragster. I was looking at running an RCD crank mount starter. The one that stays on engine. I have...
I had this happen. Was definatly frost on hat. Was only stuck open a tiny bit, but enough to make car almost impossible to slow down. High...
Thanks for the input guys.
I run a BAE 526 with Brad 5 cyl heads in a dirt dragster. Any gain in running two 44amp mags? I have everything laying around to do it except the...
I looked into this last summer. I believe your 2 choices are a 1595 or a 1705. The 1595 to get your od you want, has to use relatively small...
I blasted mine lightly and painted with endura. They look good, clean easy.
I currently run a BAE screw blown hemi in a mud dragster. I bought the engine used, and ran it last summer. Ran well. This engine currently has a...
Thanks, I seen the racing junk one but is for .100 over and I need a standard deck. Standard decks seem harder to find.
Does anyone know of a company that makes a blower manifold for BAE 5 Fat heads, standard deck height, besides BAE themselves. Theirs are made of...
I had this happen to me once. I had the check valve in return line in backwards.
Does anybody know if there is a company that makes a 14mm pulley to fit the small psi screw blower snout? I have a center to center distance of...
I have a brand new indy bbc big chief intake that is going under a psi d-screw. The rear of the top of the intake needs to be opened up to match...
Thank you. Much appreciated.
Must be a different dude. Mines been a rear engine since 2004. Thanks for the response. We fire up in June and this blower setup is new to me.
I am running 540 big chief with indy manifold and psi d-screw at 100 over with psi deep throat hat. Anybody have any experience with the port...
Whats the smallest 14mm blower pulley a person can reliably run on a screw blower? 24 tooth is the smallest I have seen made but seems to me to be...
How does one tell the differene between a D psi and a C psi? I have what is suppose to be an older D in my shop and can see no numbers/markings on...
Thanks guys. As far as the block goes its a 10.2 deck, cam is same location tho as a 9.8 block.
Whats the biggest 14mm blower pulley that will fit a bbc with standard cam location? Considering a screw blower and I am concerned about being...
Looking for suggestions on cam specs for bbc. 1871 M5 dmpe blower, roughly 40% overdriven, 545cu, big chief cyl heads, crower clutch with scs...
