Separate names with a comma.
I have a pair of Magnesium BAE valve covers that are surface worn (only the finish). In your experience what's the best to renew them ? Powder...
Hello, On my new car with a Roots blown (20%) Keith Black B1, I can see after a run (1/4) as much as 1/2 qt of oil pushed in the rear mounted...
Folks, where do you all get your gas mask from ? thanks Eric
WTB RCD gear drive for a raised cam BAE Hemi. thanks Eric eric@vantastic-racing.com
Wtb : RCD gear drive for a raised cam BAE. Thanks Eric eric@vantastic-racing.com
I have some trouble installing a MSD activate switch on a MSD Pro mag 8168 and a V300 SD computer (all on the same RPM wire) I take the rpm signal...
Who here had good results in Black anodizing magnezium ? I wish to anodize BAE valve covers Eric
Wtb +.100" Roots intake manifold for Fat heads. Eric eric@alandmo.us
Wtb valve covers for fat heads. Thanks Eric eric@alandmo.us
Wtb RCD angle hemi mag drive eric@alandmo.us
Wtb Roots style intake manifold for a +0.100" Brad fat head. eric@alandmo.us
Finally what is the manifold of choice to fit a roots BAE ? I can see 90% of BAE manifold but is it still the key to the highway ? Eric
Wtb fat head intake for Brad 6 heads on a + 0.100"block. Thanks Eric eric@alandmo.us
Hello, For all of you using a RCD/P&P dry sump oil pump, where do you locate your oil filter ? In the factory oil pump filter loop or between...
Hello What do you use to prevent Transbreak to be activatew during the run ? I thought using a RPM switch, under 2000 rpm the line lock can be...
What is the best oil pan gasket for a Brad / KB ? Please share your opinion Eric eric@vantastic-racing.com
I've been told that synthetic oil is too slippery for allowing the roller lifters to roll on the cam. It create flat spots on. Any opinion ?
Who make a low profile hemi oil pan (11 qt mini) with side quick out ? I can't use a dragster oil pan on my chassis. Eric...
What is the heavyest transmission combo : Lenco manual 3 speed with bell and clutch or a Lencodrive 3 speed & converter with the same bell...
How can you recognize a good ring from a worn one ? (except to mesure the ring gap) Is there something to check on the surface ? Also, some...