Separate names with a comma.
Are you sure the rings are being put on the pistons correctly? I hate to admit it but we chased a similar situation a few years back only to...
Have a good used 4.500 Callie's. Amr49028@msn.com or 517-795-8065
Contact Darren Kirkpatrick at Maine Fabricators. If he can't do it he will know who can.
Does anyone make a new shaft with the Dunn cross to go in my cast base or do I need a complete new billet drive? This is for a 10.2 tall Chevy....
Switching from Mallory sm+ to msd 44. Can I use the adapter that goes over the pins in my Mallory drive to a Dunn cross? Or is the load to much...
Ok, no real sign of detonation but there is one cylinder that shows significantly more heat both egt and plugs than the rest. Making a intake...
Was told by a tuner that to much advance can cause excessive blow by due to causing piston Rock in the bore and ring flutter. I'm not looking to...
If you think you may be having ignition issues call Spud at FIE. he will get you set straight. a 44 mag is overkill unless you are running nitro.
If you get the tune up right it wont detonate and push the gasket out. don't go past the 80 that arp recommended or you will stretch the stud and...
Allen, Just call ARP direct. We order direct from them all the time. If they do not stock them thay will make them for you. Jason Webb
After we have ours done I will let you know if it works if you are interested in having it done.
Ours cracked from the oil hole to the front. I am going to fix ours this winter and probably use it next season.
Is it possible that you have a crack in the rear main sadle area that when the trans brake is released and there is a load applied to the thrust...
No that will not happen. We have a neutral safty switch that is checked all the time to make sure it is working properly. The driver holds the...
Advanced chassis in Antwerp, Oh. Will make you one. I am curious though what is the reasoning for wanting the bolts to hit the block plate?
Here is how we do it. Turn fuel on crank untill you see oil pressure then open butterflys all the way open. Person who has been priming for you...
Are you sure that your pump is good? We had one that was going away once and it acted a lot like what you have described. Changed pumps and all...
Contact sassy racing engines thay have been doing this for years on there pulling engines. Probably have the parts you need in stock so you...
it is de icer so they can stage the care
I have checked that out but it doesn't say anything about being 36 volt?? Any other options here guys?
