Separate names with a comma.
As stated he is running msd 7 so thats why i said all grounds to battery. Just an opinion though.
Ground CABLE from head to head and from the same point on head straight to battery. All grounds should go straight to battery never to chassis.
So with all aluminum you need more clearance. Brian
Im was told by jeff at fowlers not to run a filter but to filter the fuel 3 to 5 times before putting into car . Not sure if thats what you want...
:confused:Ive got an all aluminum 400 sbc with about 25 passes on all parts since new. Had 10-71 standard helix and im putting a 14-71 retro hh on...
Bore As far as bore goes i think its a little loose. Measured piston skirt and cylinder and come up with 6.5 to 7 thousandths difference....
Blower pics You may be right because i havent saw any used blower pistons. If anyone could send me some pics of a blower piston with normal...
22 pounds of boost at 30 percent over.
Not sure on horsepower but it went 4.30 in the 1/8 mile weighing 1700 lbs. Its a 10/71 standard helix 23 degree heads. This is my first blown...
Havent checked bore and clearances yet , just got it apart tonight. My rod length is 6 inch.
I have a Blown 400 sbc that i just tore down and my pistons look good top and bottom but the skirts look like they come out of a cirkle track...
How did you set up the alternater with the blower stuff????????? Brian
battery Money is an issue or id buy a mag 44. So im gonna try the 10 plus but ive heard good and bad. So im just trying to prevent unnecessary...
I have got a 400 sbc with 14-71 hh retro littlefield and planning to use msd 10 and wondering which if either 12 or 16 volt battery would be...
Im putting a 14-71 on my small block chevy and i want to use a rear mag offset but clearance is an issue. Its a littlefield hh retro pie opening...
I didnt think the upright injectors would flow the air as well as the hats would.
condor Yeah, ive been trying to get some info on fowlers hat. All i know about it is that its heavy,has a divider,and cost more than a big and...
engine 400 sbc all aluminum 23 degree 14-71 littlefield k-11 rotors. Will have either 20 amp mag or 44. Im just trying to make power without...
Just wanting some opinions on aluminum injectors,,,,Which is best and if carbon fiber would be worth the extra $$$$$$$
