Separate names with a comma.
An A/FD car goes .000 last night, and .001 red this morning. (Almost) Pretty good guess work i guess.
Purchased a logger from Randy. Starting the wiring procedures. Any tips or pit falls? For the time being, doing 4 pressure sensors, g-meter, and...
I'm adding EGTs to my dragster. Is there a preference on EGT location? Short side of radius? long side of radius (aka top or bottom of zoomies)?...
Way to dominate. https://www.nhra.com/news/2019/sean-bellemeur-clinches-2019-top-alcohol-funny-car-championship-charlotte
I've updated my blower. My Mooneyham had been maintained but wasn't ever restripped. It was very loose. At 25 over it would make 16-17#s max. My...
Blown 468 BBC 8:71, bird, 110 pump, hats only 7.60 index car. Going to loop off some of the fuel pump. My idle check is 6psi. Where should i...
In my mind, i see it better that the port check be located at the dist block so the feed line stays full. Also, my idle check is 5.5#. port check...
I have a drawer of my toolbox just for blower pullies. Any cool ways devised to store pullies in a trailer? They burn up a lot of room.
First, i'm new to the pro mag world. I've had a Mallory SupermagIII for years. In the past i have used a plunger switch to ground the mag. I...
Looking for a safe -20 suit for a 6' tall/190# driver. In cert, or able to be recerted only. Prefer to have arm restraints sewn in.
Looking for a suit for my son. he's 6' / 190# Must be 2 piece, if out of cert, and will recert, that is ok. Arm restraints are a plus.
I have a stock of plugs for sale. 100 R5671-9 plugs 30 6061-9 plugs 6061-9 are 3.50 each, or $100 shipped for the lot. R5671-9 plugs are $2...
Down to one run! He got a round win today in Reading.
I suspect something is amiss with my fuel pressure reading. Earlier this year, i added a fuel pressure gauge with a check valve on it. [img]...
I thought i was on to something last week. I found a hose @ home depot to use as burndown hose. It was flexable, and light. Well, it turns out...
Looking to have a few small pieces of hardware (custom washers) heat treated. Anyone know of a shop that will do small stuff around Sacramento?
Hung up with Milodon, they won't do it. Can't get ahold of Summers Bros. Any other ideas? Everyone is telling me to order a crank with a BBC...
I'm looking online for the best bolt or stud i can buy. Any leads or opinions? Easy=grade 8 from the hardware store Better=? Best=?
Looking at taking the crank bolt from 7/16 to 1/2 (both NF) for more clamp load. This is a blown alky small block, crank has a small snout on it,...