Separate names with a comma.
Custom Velasco billet 4.5 stroke crankshaft for a blower motor application. New never ran, only installed in the engine. Uses big block Chrysler...
Thanks guys! I looked at them a few different ways and it seemed pretty obvious that the bore is what held them but wanted to make sure....
I'm finally assembling my engine and this is the first motor I have had that uses aluminum piston buttons instead of spiro-locks. I have Arias...
I have a Ford motor but its blown alcohol and when I was researching the same topic I was told that a gear drive is the way to go. The Milodon 3...
JS, I've talked with you a few times, here and on the Ford site. I've been busy out of town but am going to call C&C tomorrow to see what he has...
I bought this crank new in box, from C&C Motorsports in Virginia, and it was machined by Velasco Crankshafts, who is the company that made it. Chris
I have been in contact with the shop about every 3 months and he has just been doing a little bit at a time, very frustrating to say the least. I...
So, do you think its out of the question to tell the shop that I want a NEW crank, not one that is .010/.010? 3 grand is alot of money for a...
Here's what I have. Crank is a brand new Velasco billet 4.5 stroke, BB Ford main, Chrysler rod, going in an aftermarket Ford block. This has...
I had my iron block O-ringed and heads have receiver grooves. Question, what bore head gasket do I need to get? Bore is 4.50 and I need a .070...
One thing I was told by Carrol Carter is to be careful using a shorter rod because you can have clearance problems with the piston skirts and...
How much boost and rpm are you pushing your motor to H Brown? I'd like to get some life out of these, 75 passes would be great. Looking at 7500...
Thanks guys! Chris
Hello, I have a new set of Brooks 65 series 6.80 aluminum rods, hemi journal .990 pin, and they didn't come with any paperwork. What are the...
My build is a 4.5 bore x 4.5 stroke Ford, 10.32 deck block. I went with aluminum rods and still don't plan on shifting more than 7300 if that....
About to finish my build, its an iron block Ford 572, 4.5 Velasco billet crank with Chrysler rod journals, Arias blower pistons at 11.3-1, Brooks...
Just watched the video, awesome! Loved hearing how pumped up you were after the pass! Chris
Hi, I have a tunnel ram thats been modified for a blower with an aluminum plate welded to the top (trick flow). This a Ford motor with A460 heads...
Hello, have a few questions. I have an SSI mag blower that is black but faded and want to make it "black" again. Can I use something like VHT...
Going to stick to a dry block this time and if I have problems then will add water to see how it goes. Thanks for all the replies! Chris