Separate names with a comma.
Weight The weight is 66#s with a 40 spline steel spool and 10" Tom 's gear -complete ready to run with a 1350 yoke. Thanks , Jim
THANKS to all of our Veterans and their Familes!!!! A BIG THANK YOU to all of our Vets and sometimes we forget about the families that support...
1/2' head studs I drilled a set of Dart pro-1 345s out for the 1/2" head studs and has no problems--
Can someone help me the break down of the Kobelco serial numbers and help me determine, year model, helix and which rotors it has from the...
I need to order a couple of sets of the O-rings (thin diameter O-rings) that fit down in the spark plug hole that seals the spark plug tube bottom...
I need to order the proper #16 suction line for my pump to pan line. The so-called correct SS lines do not work sometimes as we had a line suck...
THANKS for all of the replies!!! THANKS to all rsponding and I have done everything correctly and just will have to pull everything tomorrow and...
Chrysler Starter and Flexplate I do have a matched Chrysler Starter and a 130 tooth Chrylser flexplate matched with the same DP teeth, just...
Not Enough Room THANK YOU for the reply and I had thought of the starter in front of the motor, but not enough room. I need to figure out a way...
Any ideas, help or suggestions are appreciated, and after our first trip to the track last night with a new hemi combination, I could not even...
Don, THANKS for your help! Don, THANKS for your help, all of the viewers, either did not know or had another opinion! THANKS! Jim
This is my first set of hemi heads with O-rings, I have always just used intake gaskets and the foam ends. What I am concerned about is between...
When restricting oil up to the rocker arms through the block, what size diameter hole is recommended to the top if you put allen plugs in the oil...
Piston Failers The Piston Top Coatings help keep fom Torching the top down the sides and also helping to keep from sinking the tops, if the...
Piston Coatings Thanks for all of the advice from ITA, I have contacted many of my blown alcohol friends now and they are getting twice the...
I know what the feeelings of most are about coating rod and main bearings in a blown alcohol motor, but what does everyone think about coating the...
Can someone help explain to me the difference and why they were made different later, the old style fuel heads, with the large chambers and the...
Software Copy Please send a copy to csmjimbkyle@bellsouth.net-THANKS!! Jim Kyle
Merry Christmas to all of our Soldiers! Lets all remember of Soldiers and their families who protect us and make it possible for us to have the...
THANKS for the Website! THANKS! The info I needed was there! Jim