Separate names with a comma.
I have been using the power grid with a two-step at launch (max spark advance) then using a timing curve to launch the car and minimize tire...
Dave, I am no expert but have a similar problem. I have a 4.0-inch stroke billet crank with BME rods, wedge head dodge, stage 6 KB block....
Thanks, I will check into someone who can grind the crankshaft. Do you have to use a special filler rod when welding crankshafts? Dave
Yes, I think so... I purchased it used along with several other parts. The crank is not cracked so I would like to use it, but not if it is going...
I am currently running a KB/Indy Wedge motor with a billet crank 4.0 stroke and Big block chevy mains. The oiling hole for each rod is extremely...
rear end pre-load Kurt, thanks for your feedback. I have seen the spindles on other cars but I have not looked at the details of the...
rear end preload Will do. Thanks for your help. Dave
Will, I do not want to hitchhike on another thread but I have a similar problem; the chassis is tweaked (solid FC chassis) from what the scales...
I have a question concerning rear track width. My current rear track width is 46.5 inches (center of rear tire to center of rear tire) to fit a...
Thanks for the info, Dave
More questions on gear ratio Kendrick, What size of converter (actual stall speed and size) do you use? I have thought about this...
My combination is similar 481 CI Indy Wedge with .770 lift cam 114 center installed at 108. MSD-12 with a standard helix 8/71 #21 lbs boost 110...
Blown Alcohol+Nitrous Oxide Where can I locate the pressure switch that will be 12-volts DC to activate the Nitrous solenoid. Also, would it...
Blown Alcohol and Nitrous oxide Thanks Rick I will send them and E-mail. Dave
Blown alcohol+Nitrous Oxide Thanks to everyone who replied to this thread. Dave
blown alcohol and nitrous Interested in your choice of enrichment fuel of gas instead of alcohol. Did you chose this because the system was...
I am wondering if anyone has experience with blown alcohol and nitrous oxide. I understand Dale Armstrong was very successful with a similar...
I have moved to central Pennsylvania and I am looking for a machine shop recommendation that has experience with blown alcohol motors. In...
Thanks, I will cal you later this week.
I have one Weld front spindle mount dragster wheel that was damaged around the bead seat area. The damage appears to be minimal since the tire...
