Separate names with a comma.
Hi Kyle, I've got one with a few internals, was going to rebuild, just never got around to it. Can send pictures tonight if interested.
Not sure what they are, but they're "not" Veney's...
Hi Will, Is the bellhousing still available? Not familiar with the McAmis starter location. Can it use a Mopar 130t flex plate or does it need...
Tried calling 12:00 noon, got no answer, was calling to see if you by chance had any bare 11.2 tall decks. PM me here, Thanks.
Hey Trevor, Do you still have the Lencodrive can? If so, how much life is left in the cert? Is it same depth as Lenco can? Thanks,
Thanks Mike.
Can anyone give me a quick education on the Moore Reverser units? I'm assuming they are an improvement over the Lenco reverser because I...
Hi Jim, Am interested in the Milodon block, head studs included, any repairs ( hard to believe there are any left that havn't been) saw another ad...
Do you still have these? They are a little short for my needs but may be able to juggle some head gasket thickness around. Thanks.
FWIW I had a Bruno bell develop a crack starting at the recess for the starter pocket (thin spot at edge) that worked its way about 1/3 of the way...
I don't know so I'm asking, can a well worn 2" valve with little margin be cut down to 1.950" to breathe some life back into it? If so, I've got...
That would be the plan if you're going to run AN hose on the suction side.
Hey Jim, Are you mounting in the Chevy position or stock Mopar position? I might be interested. I've got to run something down to Jeffrey sometime...
Jimmy, I can't see how they would get enough oil on the bushing in an aftermarket block since there is no pressurized oil in the lifter area....
Think it might have been clearer if they were seprated A/Fuel-------------------------------------------- Blown alcohol Rear wing: Dual...
It is entirely possible to jump a tooth on a Milodon gear drive when you tag the exhaust valves on an over-rev without any visible damage to...
This wouldn't matter to me, but what about the guys that have to go through fuel check? Wouldn't the compressed air have enough moisture in it to...
Hi Butch, Email coming.
Hi Bob, Sorry but it's for a 1 3/8th shaft
A Bruno Bell housing "will" eventually crack with a three-speed Lenco behind it that isn't supported. Crack will start in the starter pocket...