Separate names with a comma.
i believe that but i need everything including the little box that the egts go to
is there any cheaper egt sensors that will work with a racepak or are u stuck paying 1400.00 for a new set seams abit high to me thanx greg
i bought a used kb olds with big chief heads and havent had any luck from the cam manufacturer on valve lash any suggestions where to start it is...
how do you figure what rear spring rate you need for rear springs on a blown dooor car with a clutch? thanx greg
yeah i seen that i was hoping to find a more economical solution i mean at 14.95 a piec when you need 18 thats a lot of money just for one end of...
is there a place to buy the 90 degree ends when making your own hoses? hopefully economical
are the 1480 ujoints worth the extra money on a blown promod? thanx greg
trying to figure out which throwout bearing i need for 8.5/8 can with a crower 3 disc clutch and a cross shaft any help would be good thanx greg
what brand are they
does that included the coupler
it a set back i need a 6inch snout
who has the best snout for a roots blower {littlefield] just courious i need to buy one
does anybody make idler pulley brackets except rcd?
whats the best hose to use to make fuel hoses like from pump to barrelvalve and to dist. blocks and return hoses and does anybody make a preformed...
brad penn i sell brad penn in kansas if you need some let me know 785-623-0624
egts i was told any where from 2 to 4 inches from the header flange.
balance i was told by a goodyear rep that the only spin balancer that was accurate was one of the snap on hand spin balancers as the motor driven...
who makes race jacks besides pro jack? thanx greg
who makes a pan that big? all i found was 12 or 7 qt pans i have a 12 but it hangs so low
i'm running a kbolds blower motor in a promod is a 7 quart pan enough ? running an external wet pump thanx greg
