Separate names with a comma.
I just burn old methanol in my truck,mix it with some gas. I have a 2012 so its flex fuel, up to 85 percent. I had some that was almost 10 years...
Curious about the temp difference between top and bottom. Any theory as.to why? It may change my mind where I put mine.
http://www.gibbsbrandlubricant.com/ Just spray it on bare metal and wipe it in. Really good stuff. Its good for almost anything. Corey
Problem with welding aluminum that's had oil on it is the oil will wick into the crack and then wick out when the heat of the weld hits it. (dirty...
This is a point where I will respectfully disagree. I am an industrial mechanic and on gas compressors ,turbines etc the green stuff just won't...
I can't speak to the specific issues but green loctite isn't for fasteners its for bearing and shaft fits. The red is the stuff you want. It used...
Ok, so exactly the same engine as i use heads as. Well. Dry gaskets. No leakage. Learned that from shear ignorance, didn't know any better when i...
I just realized that i believe you run a hemi where im a chevy. I believe you have oil to control through the gasket? Where i don't have that...
I put my copper head gaskets on dry. O ring in the heads and receiver in the block. I've been to 35 psi so far, no issues. They pop off like...
. 050 " method here. It makes setting up my gear drive easier. Just set the lifter at the. 050 set the crank to what ever degree you want and...
I'm going to say it might have something to do with your 1st gear ratio with an extra gear added in over a 3 spd. That's my 2 cents Corey
I went with the Indy for my chevy engine. There is plenty of material in the ports to match pretty much anything you can come up with. And the...
I have basically the same engine you have 540" deal. My cam is about the same duration. Lift is .90 intake and .885 exhaust. As stated the chevy's...
Thanks Andy I was hoping you might advise about why there are 6 holes. That answers my question. Corey
Sorry to hijack but i hope this is along the same line. I am looking at a new LB22 and that blower has 6 spots for nozzles on the back of the...
I have used these on various pieces of industrial equipment and I ave never seen a metal shielded bearing sling grease. At worst they drip a bit...
Part number is easy. Just add "zz" suffix to what ever your bearing number is and that will denote the metal seals. They are made for high heat...
Have you tried a zz bearing with the metal seals. They are alot tighter then the plastic seals. Corey
A lot of time the diaphragm has a pin hole in it. That may be a little harder find a replacement. Corey
I think he under rates them to keep the fuel in a safe zone. Corey
