Separate names with a comma.
Resurfacing floater disks would like to know the depth of the 1/4" discharge slots on a new floater ? Mahalo Doug
Currently using Mooneyham rear bearing plate. Is there a manufactured plate that allows more setback of the blower for Nostalgia fuel class ?...
Aloha, Needed Hemi pushrods. 3/8" ball cup, 10.150 to bottom of cup or 10.525 overall length. Mahalo in advance : Doug Cobeen 808-987-1986 or...
Would like to purchase a 47 tooth 8mm HTD pulley. preferred set back flange or center flange, will consider flat back also. Mahalo, D Cobeen...
Wish to purchase a nice set of pins 1.156 x 3.125 heavy wall. Doug Cobeen 808-987-1986
Ready to purchase pushrods for my KB stage 5, -.500 short deck . I'm open to suggestions on what diameter would be the best choice for this...
Any one out there have a Hemi bolt pattern, Bell-housing Can w/starter pocket; approx 7 1/2" depth to fit a Quick Drive ( B&J converter drive)....
Wish to purchase a Hemi Can to QuickDrive which has a PowerGlide pump bolt pattern 7 1/4" to 7 1/2" depth. Doug Cobeen 808-987-1986
Aloha I'd like to purchase a Can, Hemi to Quickdrive, which has the PowerGlide pump pattern as the receiver. 7 1/4" / 7 1/2" depth w Starter...
Wish to install a Shogun alternator, which I have. Can anyone furnish info on the regulator needed for these to operate properly ?? Researching I...
Wish to purchase 2 Tubes to be used on 16" x 16" Center-line wheels with liners. Switching to the Dual valve stem deal. Mahalo DCobeen
Needed, Hoosier tube info ? Aloha, Retiring the old Goodyear PR-16 tubes, to install the dual valve stem setup on 16" x 16" Center-lines. (1)...
Aloha All, Can someone refer me to a web site that has identifiable (visual) pin and case, Deutsch connectors and is easy to manuver through the...
Our Community Project needs moral support. Please sign our petition to develope our new drag strip. Sign here: See details about the project...
Aloha, I run a Gen III (6.1 Hemi) NA on methanal the only bearings available are the tri layer bearings, I have put about 12 to 15 runs mostly...
Aloha, BAE early fuel head has a small crack running down about 4/5 threads (visible) I know of the replaceable threaded inserts for the repair....
Aloha all, I have pistons built by JE that were made for "Fat Head" install. Will there be any issues using them with early BAE fuel head???...