Separate names with a comma.
bruno brake clamps like no tomorrow. converter drives the car from the get go - very hard to hold it on the brakes. set up at idle with 160 psi...
Hi all i have an 11 aft 3 disk pedal clutch , can someone tell me what the static hight is to set the clutch with a dial indicator ? all our...
I have drilled and tapped my rear wheels to fit the secondary (slick to liner) valve. When screwed in, is it recommended to file them flat flush...
will a 14.5 x 33 x 15L tire work on 13 wide rim - the recommendation is 14-15 however wheel firm sent wrong size rim. as i live out of country...
Wanted to buy, bbc titanium crank shaft blower hub. shipping to oregon
wanted bird catcher injector unit, shipping to portland oregon
have a set of veney earlier heads ex nhra funny car, and a set of pistons for hemi 91 cc chambers. would these work okay as lower compression with...
Has anybody had experience with the Lucas 50 plus oil.
I have done some research regarding getting oil to the wrist pins. Dry sump, full scrapers, sump lower than crank etc etc. New pistons now have...
What is best to use to seal the drum onto the shaft of the bruno to stop it seeping. I've narrowed it down to this after replacing the seal and...
lenco CS 2 gear set 1.41 35/32 spline -this is the large fine spline, pictures available. brand new 500.00 shipped.
I'm starting to notice some people running their blower mainfolds with a gasket not the oring. I asume their using graphite type gasket? Is...
I have a perfect CS2 3 speed lenco with reverser, this is a 35 / 32 trans incls blanket and air pods. Air pods have the holley jets installed....
WTB six shooter, with chips and harnes for a 8168 would be great
What PSI pressure for a normally open lean out valve What pressure is recommended for a normally open lean out valve. I have 400, is this too...
whats a good launch rpm, tad, bruno, B & J w / 1.51 low gear, screw hemi, 508ci, 10000 rpm +
What back space would be a likely minimum for a NT/F FED for say 16 x 10? What bolt pattern is recommended? I have a spare rear end...
looking at straightening the pushrod angles up, a .180 offset would be real nice, is it worth the risk.
Any body using one of these at all, I would like some hands on info especially about the 6046