Separate names with a comma.
Looking for a forged steel BBC crank, must be 3.76 or 3.75 stroke. Prefer standard mains and rods. Looking for double keyed standard BBC snout...
Looking for (8) 4.310" bore high compression blown alky pistons. .990" pin 1.395" compression height 1/16", 1/16", 3/16" ring package Preferably...
I have an older SPE set up with 11/16" drive studs. I'm having a difficult time finding wheels that will fit them Seems like most of the wheels...
2 Used 16x15" Centerline Convo Pro drag racing wheels (no SFI sticker) with M/T 16x17x34.5" drag slicks. Wheels have 4.5" back space, 5x5 bolt...
Looking for a pair of SFI 20 firesuit pants for a friend of mine. Need to fit 5'9" 200# with a 32" inseam. Please email me what you have...
Have any of you guys experienced transmission fluid in the air lines on your B&J's? This is a fresh rebuild back from Mike and even tho' he says...
What do you guys recommend for a starting point for air pressure for tubes and liners? We run a nostalgia nitro car and have just switched from...
Guys, Do any of you have a source for a reducer for my fuel tank outlet to go from 1 7/8" to 1 1/4" ID? Thanks, Keith...
Who makes a quality front and rear intake filler pieces for a 9.8 manifold on a 10.2 BBC block? Mine were homemade and beginning to show their...
Silly question, BUT... I have a long pluger style single wire mag kill switch on my car. Do I just run that wire to the + of the coil and use the...
Guys, I need some help with my B&J 3 speed tranny. It's new to me, and since I do not know the gearing, I went to check it out. No matter which...
How do you upload one? I wanted to change mine, wound up deleting the old one and now cannot get to a field to let me upload a new one....
OK guys, I've got these SPE hubs with 11/16" drive studs on my heap. I need longer studs (now 6" OAL, need to be 6.5-6.75" OAL) Any...
Guys if I could have some help with this it would be most appreciated! We went out this weekend with my buddies nostalgia nitro funny car....
Just obtained a set of tubes and liners and would like to know the proper way to dismount and mount them. Right now, they are holding air, BUT the...
Do you guys now of the Glendora approved brake line covering that is needed? Gotta grab some for next weekend's final assembly. Thanks, Keith
I need help with installing my B&J shorty 2 speed. I have an Lakewood 8 1/8" can and a Chevy crank. The input shaft for the B&J is for a Hemi...
What is the approved flameproof paint now? Just spoke with Sean at TPR2 and they are no longer the approved coating. Keith
Looking for info on the crankshaft centerline on a KB Olds funny car with 60" out motor plate. We are having a tough time getting adequate...
OK guys looking to change from my Moroso Omni filter to a System 1, which one do I need. We run Brad Penn 70 wt in the summer and 50wt in the...