Separate names with a comma.
On my blown alky BBC after a pass, I can see on my data logger my oil PSI drops to about 60 psi at about 4.5 seconds into a run, we idle at 90psi...
All, I just have a maintenance question, what is a good grease to us on the rear bearings on a PSI 206D, and how often should you grease them?...
WE are using a ACD programmable shifter to shift a 3 speed CS-2 Lenco that is behind a Bruno on our Top dragster, But it's very unreliable, I am...
Can anyone tell me how much timing you can pull out of a 44 amp mag with a 6 shooter? and still be safe? not cross firing to and other cylinder...
All, last weekend we were running in sonoma CA, we are running a top dragster E.T. was 5.96 to 6.02, the air was pretty good the best...
What would be a safe minimum clearance between the piston and the head on a blown alky set up, grp alum rods, JE flat top pistons, copper head...
I have a 10.200 tall block BBC, I am running a 206D at 93 over and what to start pushing it more, what is the largest 8 mm lower pulley you can...
Can anyone tell me how much RPM's I will drop if I go from a 4.29 rear gear to a 4.11? we are 232mph at 9050 RPMs at the quarter mile, 17 by 34.50...
Dose anyone know who has some 34.5-17-16, part number 2922 tires in stock? thanks again Butch
All, Has anyone run the new 34.5 17 16 goodyears that have the D2a compound? the part # used to be 1022 and the new part # is 2922, any input...
Does anyone us the cool skirt cooling system under there fire suite? if so, can you get me the specs on the water pump they us to pump the cold...
What is the correct adjustment for the air servo on the lenco sc2 trans? I used the info on the lenco web site but is seems that the piston has to...
I have a blown alky psi screw, conventional head BBC, with a msd 44 amp mag with a large cap, and my question is how fare can i retard my timing...
We are running a blown alky BBC conventional heads and a 206D, we back halfed the car last year and pulled the glide (1.80 first gear) and...
Hay did any one see the Pass that Brandon Booher made at Reading's last race a few weeks ago? 5.3x at 265 mph in the second round againts Sheilds,...
I am new to the bruno's, And I want to find out what type of ATF are you guys using and why? thanks again for all of the help Butch
I have a tec question for the racers that run the Goodyear 36,17,16 slicks with beadlocks on a blown alky applacation. 1-Are these tires more...
All, my old combo was a R.E.D with a blown alky BBC psi 206D blower, power glide/ 1.80 first gear, rear gear is a 4.30. 34.5,17,16 slicks at 5.25...
All, I have been looking for a good suppier of methanol at a good price up by sonoma, what is the going price people are paying? anyone you can...
Hi all, I want to install a low gear out on my fuel system, I have a valve that will flow the same as a .085 main jet, I have it hooked up to CO2...