Separate names with a comma.
I bought mine from Dan Olson. I think Triple T makes them as well. Good luck!
Do you still have the Molinari clutch? I assume it has a ring gear? Text me at 617943foursevennineseven Thanks
Looking for a steel or TI 8-1/8 can w starter pocket, 3 disc 10.5 slipper clutch, -500 blower intake for -6 fat heads. Thanks (617)943 four seven...
Thanks guys! I'll give that a try.
Trying to regrind my floaters and hat and looking for a recommendation of what guys are using to grind these. I have a Winona FG5000 and have...
Needed RCD direct drive starter for AFD for a spare. Thanks, Tim 617-943-four seven niner seven call/text
The best read on here. Always look forward to it.
Try Arthur Gallant. He made mine. Awesome workmanship.
Clutch grinder has been SOLD. Thanks!
New Dan Olson hemi pan KB,Brad blocks $500.00 (6.5” rear x 5.5” front) Bull clutch grinder little use $2500.00 Tool tray that fits on top of...
Try HGR surplus. They usually have a variety of them. Reasonable too.
Thanks Mike. They have what I need. I appreciate the info.
Does anyone know where to buy the Future Fibres Part # FF30MLB-P-MB ? According to the rule book, if you use this MFG, you can use one rather than...
I was told at the PRI show that they had two sets of the 2.90 ratio left and that was it, and not going to make them anymore. I don't know how...
Parts found. Thanks all for reaching out.
WTB- Dunn or equivalent dual mag drive that will accept two large cap 44’s. Text 617943four seven nine seven
I ran a similar combo and used a pan that held 14 quarts and used a moroso billet pump and a accumulator with no bearing issues. However, the oil...
I agree with TAFC 577. I own a aircraft engine shop and we use CDI wrenches. Team Torque calibrates them once a year with excellent service.
Bryant-RCD spline. Order one now, they told me 18 weeks to get one.
Contact me 617943foursevennineseven Thanks
