Separate names with a comma.
Just a couple other things to touch on: If you go 4.500 bore you have to keep on top of it. 4.5 bore in a 4.8 bore space block is a little...
Depends on your application. A lot of the newer stuff has a roller bearing in the front cover which means the bearing support on the front side of...
I would say that the 2” lifter spread on the block will be worth more than the latest and greatest heads, depending what your trying to do. All...
I would be fine running regular mechanical above the blower and a standard electronic injector below the blower. I think a lot of the blower deals...
What was your total advance at idle and head temp with retarded timing vs total advance at and head temp with more advanced timing? I was taking...
I talked to some people in the know some time ago and they alluded to having trouble with the coil packs and they needing some refinement to work...
The fact of having an electronic injector above the blower scares the hell out of me. What if one quits working? What if it eats a the injector...
Out of curiosity what features would you like to see in the command module. I can think of one that I would like that the grid can do but the CM...
I agree with what Jim’s saying completely.
I would set it neutral. Make a pass in the right lane. If it drives left add some pre-load. If it drives left harder you went the wrong way. I’m...
I like to setup cars neutral if I can. If the car is driving hard to the left I will crank some preload into the passenger side top bar. When you...
Recheck your safety setting in the grid and make sure that the rpm and times dont correspond with the area your having issues. Your using the grid...
Here’s some pics of the last Lenco Drive that I did. I drilled and tapped the valve body and the case. The case I did so I could use a # 6...
From the promod section of the rule book: “Iterative transmission staging device permitted on converter cars. Manipulation of transmission or...
I have setup several of these and they are more effective if you can take the line tap out if the valve body after the converter pressure...
Thanks for posting that’s neat. My initial thought was startup oiling as well, with a hint of dirt or trash. You can take a hammer to the...
You guys are correct, sorry I wasn’t paying attention, bore is normally listed first and the stroke next, not the case here, it does state however...
Might want to recheck your math on your compression, I did the math on your 526 with that bore and stroke your at a 548 incher. The one with the...
I assume you mean Demke, Severence, Cowie? You can add Stevens to that list as he runs .20’s on command he just can’t race a full schedule due to...
.100” would be the minimum that I would run. If you call a manufacturer, they will probably tell you .250”. The biggest thing is to have some sort...
