Separate names with a comma.
Anyone have a 3d file (stl) of anyone's third member.
I am playing around with a storage drawer for our trailer and want to check clearances...
I have ask 4 different people and got four different ways on timing retard at launch.
does it really matter when you retard it?
as soon as...
Just looking for third member and see on mark williams Web page that for the ring gear and pinion there are several options.
Are any of these...
I am in need of stl files for PSI screw blower, lencodrive (3 speed), hemi motor , drag slick with bead locks and any other racing items.
Looking to replace our retainers.
What you think is best 7° or 10°?
Manley has super ti 7° but cost more, are they worth the extra?
Does anyone know of an additive that makes flames visible like nitro? Want to make night time pro mod fun to watch.
Mark Williams 10"
they all bout a grand or little more
looking to replace toms 5.29
we run a set for 2 years then replace...
If leaving on two step and wide open throttle does the leakage percentage really matter?
if you have correct fuel flow
Has anyone used both and have opinion on which is best?
How critical is gallon per minute number?
I mean if say plugs look best at 17 gpm how much can you very and not notice difference in time slip....
Due to all the scam emails I am deleting this
I am thinking about having our valve covers hydro dipped.
Any body done this?
Has it held up?
Need to buy Lenco CS2 reverser case in good shape
don't need a cracked one, got one of them:D
also would like to buy 36-37" carbon fiber drive...
do you think it will hold up to pro mod race power? need to rebuild third member and want yall opinion
plan to use Tom's 10' rear gear
Has anybody built their on flowbench for fuel pump? If yes would you post how and how to do it the right way
4:5 GROUND CLEARANCE
Minimum 3 inches from front of car to 12 inches behind centerline
of front axle; 2 inches for remainder of car, except oil...
would you tell me approximate flow at 9000 rpm for either of these gear sets
which series you use?
I recently had 663HND version all burnt and ended in major engine damage
~5 passes on bearings with 3 oil changes in...
has anyone used this process for their frame?
how do they compare:
Powder coating, Durability, weight, cost
Spray paint, Durability,...
what is max timing retard for the small cap before I will run into trouble?