Crankshaft Source

Let's say that a person was going to order a couple of new cranks, plus a couple of new spares, for a screw blown alky type setup (4 cranks in total).

What would be your recommendations? Bryant, Winberg, or Crower? On the material side EN30B? On the treatment side, do you recommend cryogenic treatment?

Any thoughts would be appreciated. These will be going into billet blocks.

Thanks.

 

cranks

We use and sell Bryants, In our set up we hard chrome the bearing surfaces. This is a little insurance for the bearings, but does make the crank slightly stiffer. If you PM me I will work out a 4 crank price for you on all new cranks, any stroke.
Wayne Butler

 

Bryants are definetley a good peice

 

Spend the Xtra $$$ and buy Bryant.