Lenco Front seal part number

Does anny one know the part number on the front seal of a CS1.
or even better the size. all measurements.

 

http://www.lencoracing.net/

 

I think he is looking to purchase one locally. I dont remember the part # but it was only like 8 bucks and I didnt have to pay an additional 10 bucks for shipping and wait three days to get it.

 

The Nantional seal number is 8516N

 

I have bought that seal locally several times. If you are pulling trans several times during an event to change clutch you will want to have a few extra of these seals in the trailer. The only problem I had with the local seals was the outer flange is oversize on some of them and it hangs up on the bellhousing when you pull the trans. I sanded the flange off on those. I have bought the Napa and Carquest versions and I can't remember which ones were the pain and which weren't. But most importantly they all worked and I didn't have to pay shipping. Dave Germain

 

seal

hi jonas we have them and if you don't find the seal i give you 1 in mantorp see you there grtz danny

 

sealing lenco

The problem is that we have a little oil on the back side of the pressure plate after a run . I had a new sealing mounted but its still a little oil on the backside of the pressure plate, ordered two more sealings for Mantorp so I see you there !

 

pull the ring gear out and change the bearing to a rubber shielded bearing
put some silicone around input shaft where the seal ring in pressed on to the shaft
this will stop the oil
your shifter pods are probably leaking air into the trans