CNC m/c brake bias

i have one of the cnc dual side by side master cylinders popular on funny cars.i've seen on many cars a pretty severe difference in the length of the two rods,only i don't remember which is which and i'm sure mine is probably wrong....what is the correct way to set the bias?.....thanks...

 

Miles, On the back of mine it has the boar size. Left side is front brakes and right is rear. Adjust the smaller boar rad to the front brakes so that when you grab a handfull of brake the front tire barley moves. Call John V around the corner. He can set ya up. You ready to run your car yet ?

 

thanks, i'll try the old trial and error method then.yep car is rready.i made a couple of half track runs at vegas in november.steering and brakes needed attention.going to bakersfield next weekend to try and get some licencing runs in....hope to see you there .cheers Miles......

 

If we have the holy toledo done I may be there. see ya