Veney help

Discussion in 'PSI Superchargers Tech Questions' started by jay70cuda, Jan 24, 2019.

  1. jay70cuda

    jay70cuda Well-Known Member

    Joined:
    Sep 30, 2009
    Messages:
    1,139
    Likes Received:
    35
    hey guys I’m trying to help a guy out with Veney stuff and wanting to make sure I don’t go down the wrong path.
    Seat psi? Seems low 350-400 ? When my Brad stuff is 600
    Will the valve train handle the 2 step or need a air throttle launcher?
    It’s a 4.500 deal. Same on the rods 2 runs then toss em?
    What about oil, 70 wt still?
    I’m thinking the rpm range is much lower than my deal.
    Thanks in advance
     
    #1
    jay70cuda, Jan 24, 2019
  2. Will Hanna

    Will Hanna We put the 'inside' in Top Alcohol
    Staff Member

    Joined:
    May 6, 2003
    Messages:
    6,706
    Likes Received:
    132
    I would call Bob Newberry.

    The seat pressure you referenced is pretty common because they don't take the big seat pressure very well.

    I was told Manton is working on a Veney assembly.
     
    #2
    Will Hanna, Jan 28, 2019
  3. sean70ss

    sean70ss Member

    Joined:
    Dec 15, 2004
    Messages:
    635
    Likes Received:
    2
    #450 on the exhaust side min. Shift 9200-9400. Is it a pinch head? They make tons of torque down low leave at 3200-3400. No more then 28 on the timing.
     
    #3
    sean70ss, Jan 28, 2019

Share This Page





XenPorta 2 PRO © Jason Axelrod from 8WAYRUN.COM