44 mag, weld , strange, Lenco , Hogan

weld liner rim 16x16x5 has valve stems installed, top fuel center . Been keep as a spare rim but if I need it then some bad ish must of happened. $800
Lenco cs1 fine spline 1.46 gear set with basket $750
Cs1 fine spline 1.48 gear set with basket $750
Hogan sheetmetal intake for .100 tall bae. Set back , top has been flattened with surface grinder for .001 tollerence. Updated with a o ring gasket. Also the intake rail has a o ring installed for superior sealing. Will include nozzle bodies and burst panel with it. No lines , blower stud , or distribution block. $2000
Strange steel front brake kit off ultra struts , have multiple brackets and sets of pads. Rotors have 85% life left. $200
60 mm bae camshaft 118 lobe separation. Have the cam card but don’t want to post specs , good for lower od and rpm. Went 5.95@244 in 2700 lb car 20% od on blower $300
New carbon drive shaft from driveshaft shop. Ordered wrong length. No yoke , 1350 u joints Paid $900 will sel for $600
Msd 44 mag complete setup out of the car.
44 amp mag upgraded to 56 amps from system 1. Was a brand new mag when it was upgraded , blueprinted and whatever else they did at system 1. I just know it was a $800 update
2 points boxes 1 new this season other 2 years ago
Coil psi tests as brand new still.
2 sets of Moroso hemi wires that psi and load test as new
New coil wires at least 5-6
2, Msd 2 step modules chip version
1 - dial select msd2 step
Board full of high side / low side chips
Mag clamp
Mag support clamp
Fire proof sleeve
Black rcd mag drive offset for .100 tall Brad. Was new this year
As of right now I’m not parting this out. I bought all this new overnight the last 5 years
At some point. It has never been blown up, on fire or damaged in any way. It’s been back at system1 every year for check ups and paid over $8100 for all this. Asking$4800
I have pics of everything and more parts coming soon. Text me before leaving a message here
Thanks jay 248-884two178
Kalsomotorsports8749@gmail.com

 

do the points boxes have rev limiters

 

Yes . It is the rev limiter boxes