Lenco Fitment

Discussion in 'PSI Superchargers Tech Questions' started by tafc1445, Jan 22, 2016.

  1. tafc1445

    tafc1445 Member

    Joined:
    Nov 19, 2014
    Messages:
    35
    Likes Received:
    1
    What is the minimum required length between the engine plate and rear end centre line for easy removal/install of a 3 speed CS1 with 8 5/8" can.
     
    #1
    tafc1445, Jan 22, 2016
  2. Bob Meyer

    Bob Meyer Comp Eliminator

    Joined:
    May 13, 2003
    Messages:
    766
    Likes Received:
    39
    Back of motorplate to axle Centerline with 9 - 9.5" Ford =47"
    Must use what Lenco lists as "Meyer Output shaft".
     
    #2
    Bob Meyer, Jan 23, 2016
    Lennon300 likes this.
  3. tafc1445

    tafc1445 Member

    Joined:
    Nov 19, 2014
    Messages:
    35
    Likes Received:
    1
    Do you know the length of that type of output shaft. The one I have in the main gearbox now is 7 3/8" long from the end of both splines not including the spigot. The one in the spare box is the extra long shaft which I was going to trim to the same length.
     
    #3
    tafc1445, Jan 24, 2016
  4. Bob Meyer

    Bob Meyer Comp Eliminator

    Joined:
    May 13, 2003
    Messages:
    766
    Likes Received:
    39
    Bad info........sorry, should be 46" back of motor plate to axle centerline. Output shaft must have 3.5" full spline (not counting radius) tips of radius ending at seal. Remember, if you go to a ten inch gear set, the pinion is longer.
     
    #4
    Bob Meyer, Jan 26, 2016

Share This Page





XenPorta 2 PRO © Jason Axelrod from 8WAYRUN.COM