Using fatheads w/ a 1.8" Lifter spread block

Discussion in 'PSI Superchargers Tech Questions' started by Soldierboy0098, May 17, 2015.

  1. Soldierboy0098

    Soldierboy0098 Active Member

    Joined:
    Feb 17, 2006
    Messages:
    1,420
    Likes Received:
    16
    Asking for a friend, I was originally told that you could use fatheads w/ a 1.8" Lifter spread block with a little clearancing. The block is .100 tall if it matters.

    Does anyone have first hand experience in running this setup?

    Thanks,
    Trevor Sherwood
    727-364-4368
     
    #1
    Soldierboy0098, May 17, 2015
  2. nitrowannabe

    nitrowannabe Member

    Joined:
    Oct 9, 2006
    Messages:
    414
    Likes Received:
    20
    Not sure about lifter spread problems but the fatheads have a different pushrod angle. Lots of grinding near the top of the block for the KB pre Stage 10. .100 tall may be past this problem.
     
    #2
    nitrowannabe, May 17, 2015

Share This Page





XenPorta 2 PRO © Jason Axelrod from 8WAYRUN.COM