Littlefield 1271 hi helix injectors(at top rear of blower) are squirting alcohol idle

Discussion in 'PSI Superchargers Tech Questions' started by koister, Dec 21, 2014.

  1. koister

    koister New Member

    Joined:
    Feb 23, 2012
    Messages:
    28
    Likes Received:
    0
    Hi,
    I just put new teflon strips in the blower reassembled it started the car an alcohol is shooting out of the injectors that are located at the rear of the blower. The injectors going into the hat are working fine. This is a blown alcohol 572 ci hemi. This was not an issue before the blower rebuild. Did i do something wrong when reassmbling? Any suggestions would be appreciated.Just to be clear i am talking about the injectors located at the rear of the blower that inject directly into the blower case.
    Thanks in advance,
    Kenneth Oister
     
    #1
  2. h2b puller

    h2b puller Member

    Joined:
    Feb 8, 2008
    Messages:
    73
    Likes Received:
    1
    Check if the rotors are put in right, if the left and right rotor are changed it will push out fuel on the rear nozzles and will make no rpm.
     
    #2
  3. koister

    koister New Member

    Joined:
    Feb 23, 2012
    Messages:
    28
    Likes Received:
    0
    Thanks for the reply. I thought that might be the problem but wanted to ask before i tore the hole thing apart again.
    ken
     
    #3
  4. secondwindracing

    secondwindracing top alcohol

    Joined:
    Feb 10, 2004
    Messages:
    2,894
    Likes Received:
    7
    swap your rotors..if it has been serviced most likely on the ends it will have a R and a L
     
    #4
  5. koister

    koister New Member

    Joined:
    Feb 23, 2012
    Messages:
    28
    Likes Received:
    0
    swapped rotors

    Thanks for the input. I serviced the blower and obviously installed the rotors wrong. I didnt think that they looked right when i put it back together. Anyway, I swapped them per your advice and bingo everything is good.
    Thanks again for taking the time to give me advice.
    Ken
     
    #5

Share This Page