Common lifter bore and cam bushing diameters?

What are the common diameters for hard running blown alky engines like BAE, AJPE and MBR?

I'm assuming the common lifter diameter is .904 or .937?

What about the cam, are they 60mm?

 

.904 and 60mm is pretty common. Some engine builders use 1.000 lifters.

 

lift me

if you want to see some of the neatest new stuff check out jessels slot offset cam lifters and cam setups moran is using. completely different tech and way of thinking. may be standard equipment in a few years for unlimited classes. looks very expensive, though. there was a article on page 82 of September issue of drag racing action magazine. check it out.