Lenco Drive

Discussion in 'PSI Superchargers Tech Questions' started by quick cut, Mar 4, 2013.

  1. quick cut

    quick cut Member

    Joined:
    May 22, 2007
    Messages:
    107
    Likes Received:
    0
    Lenco Drive what rpm can you rev to when in stage, with out pulling through & frying the clutches.
    convertor locks up & pull motor down at 6300rpm
    What are people leaving the line at ?
    Thanks
     
    #1
    quick cut, Mar 4, 2013
  2. underby6

    underby6 Active Member

    Joined:
    Sep 28, 2006
    Messages:
    1,189
    Likes Received:
    0
    You can leave just about anywhere, you may need to put some psi. on the brake to ensure it doesn't roll. It appears you have a converter issue, the Lencodrive isn't going to alter where the motor flashes to. You can attempt leaving at a higher RPM but if you're already too tight you're only going to gain maybe a hundred or two rpm. Feel free to give me a call if you want to discuss this further, you can also email me.

    Brandon Booher
    NHRA TAD #323
    Torque MGMT. - Owner
    217.840.1500
    underby6@gmail.com
     
    #2
    underby6, Mar 4, 2013
  3. quick cut

    quick cut Member

    Joined:
    May 22, 2007
    Messages:
    107
    Likes Received:
    0
    Brandon thanks for the reply sounds like you run one I will send you a email as soon as I get time.
    It will come from quick cut concrete
    Thanks Dave
     
    #3
    quick cut, Mar 7, 2013

Share This Page





XenPorta 2 PRO © Jason Axelrod from 8WAYRUN.COM