Educate the Canadian

Discussion in 'PSI Superchargers Tech Questions' started by steve3410, Aug 7, 2012.

  1. steve3410

    steve3410 New Member

    Joined:
    Sep 5, 2008
    Messages:
    28
    Likes Received:
    0
    I did a search and think receiver grooves would help seal the cyl better. I'm having gasket probs on blown sbc. I've had .035 orings put in .020 deep but dont know where or how deep to put receiver grooves, and are they square or half round?
    Thanks Steve
     
    #1
    steve3410, Aug 7, 2012
  2. B.DOUCET

    B.DOUCET New Member

    Joined:
    Jun 15, 2004
    Messages:
    317
    Likes Received:
    0
    Cut the receiver groove .008 to .010 bigger than the o-ring, .010 to .012 deep.
     
    #2
    B.DOUCET, Aug 8, 2012
  3. chutedragger

    chutedragger Member

    Joined:
    Dec 21, 2010
    Messages:
    65
    Likes Received:
    1
    Ran a blown 350 at 30 lbs, had copper gaskets, and O'rings, that were marginal....switched to a cometic gasket and it was awsome!! Sealed when cold (for leak down checking too)
     
    #3
    chutedragger, Aug 13, 2012
  4. steve3410

    steve3410 New Member

    Joined:
    Sep 5, 2008
    Messages:
    28
    Likes Received:
    0
    Did You run the cometics with orings?
     
    #4
    steve3410, Aug 14, 2012

Share This Page





XenPorta 2 PRO © Jason Axelrod from 8WAYRUN.COM