lenco shaft splines

what shaft do i need to use the 25% planet to the right? is this an old obsolete part or what?

 

The 25% and 28% gearsets use a smaller intermediate shaft. I assume that you can purchase the shaft by itself from Lenco.

 

it's a CS-1

 

What he said.

 

lenco shafts

call lenco, the shaft for 25% is smaller in the planet carrier

 

your mailbox is full

 

The 25% setup uses a shaft that is smaller on the end ------------ only for a 25% I'm told as I just got off the phone to Lenco-------------------as I ran into this a few weeks ago swapping gearsets from several transmissions ---------------

 

I believe the shaft for the front case is different from the second case
so depending on which case you use it in
But i could be wrong just cant remember for sure

 

You are correct.

 

What does the case have to do with this situation ? I figure I might learn something here . Thanks

The issue I found was the spline od on the 25% shaft is a smaller diameter than the others---- I called Lenco and they told me the 25% was the only one that used the smaller shaft -----------------

So as I understand it the 25% planetary and the shaft will fit in any CS 1, true ?

Maybe what John is referring to is a three speed ? I am thinking 2 speeds.

 

Mark
I was refering to a three speed, most of us use them
the shaft for 2 sped versus a 3 speed ( case#1 vs case #2)
if i remember right is different lengths because of the reverser or case lengths
but its been a while since I have done this
maybe some one remembers for sure

 

That makes sense John, thanks.