inside cyl. head tool

Discussion in 'PSI Superchargers Tech Questions' started by Don Onimus, Jul 25, 2010.

  1. Don Onimus

    Don Onimus New Member

    Joined:
    Feb 28, 2009
    Messages:
    1,337
    Likes Received:
    0
    Go figure, I can,t find my snap-on catalog. Does anyone know a number I can give my guy for the tool. It is the bone shaped off-set one for 9/16 nuts for the inside studs. Want to call him so I can get it when he stops by this week.. Just easier than me trying to describe it. Thanks Don
     
    #1
    Don Onimus, Jul 25, 2010
  2. hemi altered 378

    hemi altered 378 Blown Altered

    Joined:
    Jul 3, 2004
    Messages:
    864
    Likes Received:
    0
    i am not sure on the 9/16"....but the number on my 1/2" is FRDH161
    hope this helps
     
    #2
    hemi altered 378, Jul 25, 2010
  3. TD381

    TD381 Member

    Joined:
    Dec 23, 2006
    Messages:
    44
    Likes Received:
    0
    Snap-on torque adaptor

    FRDH181 is 3/8" drive, 9/16" 12 point, 2" center to center.
    Can also use spline drive p/n FRES18 - 9/16 and FRES16 - 1/2".
    SRES18 is 1/2" drive, 9/16" 12 point, 3" center to center.

    East to look up at: www.snapon.com

    Steve Christophersen
     
    #3
    TD381, Jul 26, 2010
  4. blown375

    blown375 New Member

    Joined:
    Sep 9, 2005
    Messages:
    733
    Likes Received:
    0
    #4
    blown375, Jul 26, 2010
  5. Don Onimus

    Don Onimus New Member

    Joined:
    Feb 28, 2009
    Messages:
    1,337
    Likes Received:
    0
    Tool

    Thanks Guy's Had to order a few things from Brad, so I just got it from there. Again Thanks Don
     
    #5
    Don Onimus, Jul 27, 2010

Share This Page





XenPorta 2 PRO © Jason Axelrod from 8WAYRUN.COM